... | ... | @@ -134,7 +134,7 @@ This file specifies how to translate the sliced geometry to printing instruction |
|
|
| ```header()``` | called to create the header of the G-Code file |
|
|
|
| ```footer()``` | called to create footer of the G-code file |
|
|
|
| ```comment(c)``` | called when outputting a comment ```c``` |
|
|
|
| ```layer_start(z)``` | called at the start of a layer at height ```z``` |
|
|
|
| ```layer_start(z)``` | called at the start of a layer at height ```z``` (mm) |
|
|
|
| ```layer_stop()``` | called at the end of a layer |
|
|
|
| ```extruder_start()``` | called before extruding |
|
|
|
| ```extruder_stop()``` | called after extruding |
|
... | ... | @@ -147,7 +147,7 @@ This file specifies how to translate the sliced geometry to printing instruction |
|
|
| ```move_xyze(x,y,z,e)``` | called when traveling to ```x,y,z``` while extruding to value ```e``` |
|
|
|
| ```progress(percent)``` | called on each step of producing the GCode; ```percent``` is the total progress of the print |
|
|
|
| ```set_feedrate(rate)``` | called when setting the feed-rate of the printer to ```rate``` |
|
|
|
| ```set_fan_speed(speed)``` | called when setting the part cooling fan velocity to ```speed``` |
|
|
|
| ```set_fan_speed(speed)``` | called when setting the part cooling fan velocity to ```speed``` (%) |
|
|
|
| ```set_extruder_temperature(ext,temp)``` | called when setting the extruder ```ext``` temperature to ```temp``` |
|
|
|
| ```wait(sec,x,y,z)``` | called when the parameter ```enable_min_layer_time``` is set to true and the printing time for the layer is less than ```min_layer_time_sec```. ```sec``` is the remaining time to achieve ```min_layer_time_sec``` and ```x,y,z``` is where IceSL expects the head to be after the wait |
|
|
|
| ```set_and_wait_extruder_temperature(ext,temp)``` | called when setting the extruder ```ext``` temperature to ```temp``` while waiting. Used when printing with multiple extruders |
|
... | ... | |