Attention une mise à jour du service Gitlab va être effectuée le mardi 18 janvier (et non lundi 17 comme annoncé précédemment) entre 18h00 et 18h30. Cette mise à jour va générer une interruption du service dont nous ne maîtrisons pas complètement la durée mais qui ne devrait pas excéder quelques minutes.

Commit 383e40e9 authored by Ludovic Courtès's avatar Ludovic Courtès
Browse files

article: Move figure and table labels after \caption.

* article/content.tex: Move all \label after \caption.  This fixes
cross-references.
parent 07f3b168
......@@ -87,8 +87,8 @@ Libtool that were current back then since today's versions are
incompatible. Fortunately, the ``downgrade cascade'' stops here.
\begin{figure}[ht!]
\label{fig:dependencies}
\caption{Dependency graph for the 2006 revision of libchop.}
\label{fig:dependencies}
\includegraphics[width=.7\paperwidth]{libchop-graph}
\end{figure}
......@@ -130,8 +130,8 @@ the ``mailbox'' file set, we chose the mbox-formatted archive for
the \texttt{guix-devel@gnu.org} mailing list.
\begin{table}
\label{tab:file-sets}
\caption{File sets.}
\label{tab:file-sets}
\begin{tabular}{l|c|r|r}
\textbf{Name} & \textbf{Size} & \textbf{Files} & \textbf{Average Size} \\
\hline
......@@ -149,8 +149,8 @@ specification} of these file sets that accompanies this article.
\subsection{Evaluation Results}
\begin{table}
\label{tab:configurations}
\caption{Storage pipeline configurations benchmarked.}
\label{tab:configurations}
\begin{tabular}{c|c|c|c|c|c}
\textbf{Config.} & \textbf{Single Instance?} & \textbf{Chopping Algo.} & \textbf{Block Size} & \textbf{Input Zipped?} & \textbf{Blocks Zipped?} \\
\hline
......@@ -183,8 +183,8 @@ data size to the input data size) and Figure~\ref{fig:throughput} shows
the throughput of each storage pipeline, for each data set.
\begin{figure}[ht!]
\label{fig:size}
\caption{Ratio of the resulting data size to the input data size (lower is better).}
\label{fig:size}
\includegraphics[width=.7\paperwidth]{charts/size.pdf}
\end{figure}
......@@ -197,8 +197,8 @@ different defaults, such as a larger compression buffer, allowing it to
achieve better compression.
\begin{figure}[ht!]
\label{fig:throughput}
\caption{Throughput for each storage pipeline and each file set (higher is better).}
\label{fig:throughput}
\includegraphics[width=.7\paperwidth]{charts/throughput.pdf}
\end{figure}
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment